IC-R5 Specifications and Options
This information is taken directly off of the ICOM IC-R5 brochure.
General
- Frequency Range (Canada):
- Mode: FM, WFM AM
- Tuning Steps: 5, 6.25, 8.33*, 9*, 10, 12.5, 15, 20, 25, 30, 50, 100 kHz
- * selectable depending on operating bands
- Number of Memory Channels: 1250 (1000 regular, 200 auto memory write, 50 scan edges)
- Usable Temperature Range: -10°C to +60°C; +14°F to +140°F
- Current Drain (at 3.0 V DC):
- Rated Audio: 170 mA typ.
- Standby: 100 mA typ.
- Power Saved: 41 mA typ.
- Battery Requirement: 2 x AA (R6) Ni-Cd or alkaline cells
- External Power Supply Requirement: 6.0 V DC ±5% (with BC-136A or CP-18A)
- Antenna Connector: SMA (50 ohms)
- Dimensions:
- 2.3 W x 3.4 H x 1.1 D inch, 6.5 oz.
- 58 W x 86 H x 27 D mm, 185 g
Receiver
- Receive System: Triple conversion superheterodyne
- Intermediate Freq.
- 1st: 266.7 MHz
- 2nd: 19.65 MHz
- 3rd: 450 kHz
- Sensitivity (except spurious points; typical):
- FM (at 12 dB SINAD)
- 1.625 - 4.995 MHz, 0.32 µV
- 5.000 - 117.995 MHz, 0.2 µV
- 118.000 - 246.995 MHz, 0.18 µV
- 247.000 - 329.995 MHz, 0.2 µV
- 330.000 - 469.995 MHz, 0.18 µV
- 470.000 - 999.995 MHz, 0.28 µV
- 1000.000 - 1309.995 MHz, 0.35 µV
- WFM (at 12 dB SINAD):
- 76.000 - 108.000 MHz, 0.89 µV
- 175.000 - 221.995 MHz, 0.71 µV
- 470.000 - 770.000 MHz, 1.0 µV
- AM (at 10 dB SINAD):
- 0.495 - 4.995 MHz, 1.3 µV
- 5.000 - 29.995 MHz, 0.71 µV
- 118.000 - 136.000 MHz, 0.56 µV
- 222.000 - 246.995 MHz, 0.56 µV
- 247.000 - 329.995 MHz, 0.71 µV
- Selectivity
- AM, FM: More than 15 kHz/-9 dB, Less than 30 kHz/-60 dB
- WFM: More than 150 kHz/-6 dB
- Audio Output Power: 100 mW typical, at 10% distortion with an 8 ohm load.
- External Speaker Connector: 3-conductor 3.5(d) mm (1/8"), 8 ohms
Supplied Accessories
- Two rechargeable AA Ni-Cd cells and AC adapter charger
- Antenna
- Hand strap
- Belt Clip
Options
- CS-R5 CLONING SOFTWARE: Provides quick and easy programming of memory channels, memory names and set mode contents via an IBM® compatible PC.
- OPC-478 CLONING CABLE: RS232C cable for PC programming of the receiver
- OPC-478U CLONING CABLE: USB cable for PC programming of the receiver
- OPC-474 CLONING CABLE: Allows you to transfer data between receivers.
- LC-146A CARRYING CASE
- HP-4 HEADPHONE: Lightweight monaural headphones
- SP-13 EARPHONE: Provide clear audio in noisy environments
- AD-92SMA ANTENNA CONNECTOR ADAPTER: Allows you to connect a BNC type antenna cable
- BC-149A Ni-Cd CHARGER: Same as supplied.
- CP-18A - CIGARETTE LIGHTER CABLE
All specifications and options subject to change without notice or obligation.